Page 1 of 1

Needed: AdamNet character routines for SmartBasic

Posted: Tue Feb 01, 2022 1:04 pm
by tschak909
What would really be beneficial would be to do a set of routines for SmartBASIC that can read and write from any AdamNet character device. This would allow for an early implementation of #FujiNet control and network support.

All of the networking and fujinet control features can be accessed using EOS Read/Write Character device calls.

This could tide over, until SmartBASIC 1.x can be patched to add native FujiNet commands. (If I remember right, the source for 1.x was released?)